Publicaciones en las que colabora con SUSANA MARTÍNEZ PELLITERO (48)

2023

  1. Design of Supports to Avoid Deformations in the Process of Alumina Printing by Stereolithography

    Key Engineering Materials (Trans Tech Publications Ltd), pp. 67-75

  2. Optimization of Sandblasting to Improve the Surface Finish of 17-4PH Parts Manufactured by SLM Using Different Laser Scanning Strategies

    Key Engineering Materials (Trans Tech Publications Ltd), pp. 97-103

  3. Procesos de fabricación aditiva de piezas cerámicas

    Fabricación aditiva (UNED - Universidad Nacional de Educación a Distancia), pp. 301-329

2021

  1. Evaluation of the Influence of Post-Processing on the Optical Inspection Accuracy of Additively Manufactured Parts

    Manufacturing Engineering Society International Conference, MESIC 9: Gijόn, 2021, Spain, June 23-24-25

  2. Evaluation of the influence of post-processing on the optical inspection accuracy of additively manufactured parts

    IOP Conference Series: Materials Science and Engineering, Vol. 1193, Núm. 1, pp. 012062

  3. Influence of printing conditions in Binder Jetting on the resin infiltration post-processing

    IOP Conference Series: Materials Science and Engineering, Vol. 1193, Núm. 1, pp. 012041

  4. Influence of printing conditions in Binder Jetting on the resin infiltration post-processing

    Manufacturing Engineering Society International Conference, MESIC 9: Gijόn, 2021, Spain, June 23-24-25

  5. Laser defocusing effect on the microstructure and defects of 17-4ph parts additively manufactured by slm at a low energy input

    Metals, Vol. 11, Núm. 4

  6. Laser line scanner aptitude for the measurement of Selective Laser Melting parts

    Optics and Lasers in Engineering, Vol. 138

2018

  1. Characterization of materials used in 3D-printing technology with different analysis techniques

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

  2. Knowledge base model for automatic probe orientation and configuration planning with CMMs

    Robotics and Computer-Integrated Manufacturing, Vol. 49, pp. 285-300