Experimental and Numerical Study of Silo Filling Using Pellets

  1. Rômulo Marçal Gandia 1
  2. Angel Ruiz Padin 2
  3. Gerardo Hernández Rodrigo 2
  4. Luis Herráez Ortega 2
  5. Alberto Tascón Vegas 3
  6. Pedro José Aguado Rodriguez 2
  1. 1 Universidade Federal de Lavras

    Universidade Federal de Lavras

    Lavras, Brasil

    ROR https://ror.org/0122bmm03

  2. 2 Universidad de León

    Universidad de León

    León, España

    ROR https://ror.org/02tzt0b78

  3. 3 Universidad de La Rioja

    Universidad de La Rioja

    Logroño, España

    ROR https://ror.org/0553yr311

European Conference on Agricultural Engineering AgEng2021

Editorial: Universidade de Évora

ISBN: 978-972-778-214-7

Ano de publicación: 2021

Páxinas: 225-231

Tipo: Achega congreso


At present, different biological materials, agricultural crops or forest products are susceptible to be industriallytransformed to be used as solid biofuels. The most common presentation for these materials is in the form of pellets,whose storage is carried out mainly in hoppers, silos or bunkers. However, there is an important lack of knowledgeabout the mechanical behaviour of these stored materials, what causes difficulties in the structural silo design.Numerical models have proved to be a useful tool to analyse this phenomenon and even for the design of silos.However, numerical models need parameters that must be experimentally obtained and finally they must be validatedby experimental assays.The objective of this work is to present a finite element model developed by the authors to simulate the mechanicalbehaviour of pellets that have been stored in a silo. This model has been compared with the experimental resultsobtained using a real scale silo test.The experimental analysis was performed at the experimental station located at the University of León, designed andbuilt by Couto, Ruiz & Aguado (Couto et al., 2012; Ruiz et al., 2012). The parameters such: specific weight, modulus ofelasticity, internal friction angle, wall friction coefficient, angle of repose and Poisson’s ratio were determinedexperimentally.The numerical model was made in 3D, using Ansys 2021R1 software. For simulate the filling stage all nodes placedat the hopper shell of the silo were totally restricted. The behaviour of the pressures in the silo and hopper were verified,as well as the displacement of the grains and the directions of the main stresses.